'T + K' wall bracket set for 1" to 2" pole

Suitable for mounting a large dish or aerial on a pole.

Please order pole and dish or aerial separately.

Brackets require 5 fixing bolts in total.

All bracket sets include two U bolts to clamp a pole of up to 2 inches (50mm) diameter.

(Also great for hanging ladders and bikes on the wall!)

Choose galvanised or painted from the drop-down list, below.

We recommend you prime and paint poles and brackets with an oil-based paint.
You can also add to the protection by wrapping exposed parts with Denso tape.

Our T & K brackets are measured in inches from wall to end of bracket.
Select size from drop-down list, below.

The centre of the pole is usually around 2.5 inches from the end.

Note: 12" = approximately 305mm.
2.5" = approximately 63.5mm.

We can also supply a suitable pack of 5 bolts, plastic plugs and washers. Please change the Qty below if you require one or more packs.

The correct way to assemble a bolt.

Most professionals don't do it this way because it takes longer.

• The bolt is coated with grease to ensure that it can be removed years later.
• The Blu-Tack further seals the hole, keeping water out.
• The washer next to the wall creates a raised "plinth".*
• The washer under the bolt head allows the bolt to turn easily.

*When a T+K bracket is fitted to a wall without washers, it can rest on raised bricks causing the pole to twist away from the vertical. Washers can be used for fine adjustment (important for a motorised dish. Less important for a fixed dish.)

Send this page address - CLICK HERE - to a friend !