Channel Master moulded dishes by Andrews

Note: Channel Master items are Special Order items from America so delivery is typically 6 - 8 weeks.

UK mainland delivery only (due to carriage and insurance cost).

*Note: "SMC" = Sheet Moulded Compound with embedded metal mesh

The 90cm and 1.2m dishes can be motorised only if you use the polar mount instead of an AZ/EL mount. You will also need a jack arm (linear motor) and a suitable positioner to control it. See illustration on left. You WILL need to order either an AZ/EL mount or a polar mount (but not both). You will also need a suitable 3" diameter pole or mount.

Unfortunately, we can no longer obtain the polar mount.

UK mainland delivery only (due to carriage cost).

If you have only the 1.0m dish face you will need to order the LNB bracket kit and the kit of 3 "Feed Legs" which support it.

Spare Parts

3 rods, bent, with internal thread

Plastic mouldings with bolts to fit an LNB with 40mm diameter neck.

Note: The threaded brass inserts may need to be filed down so that the two "bridge" mouldings can grip the LNB properly.

UK mainland delivery only (due to carriage cost).

*Note: "SMC" = Sheet Moulded Compound with embedded metal mesh

The 90cm and 1.2m dishes can be motorised only if you use the polar mount instead of an AZ/EL mount. You will also need a jack arm (linear motor) and a suitable positioner to control it. See illustration on left. You WILL need to order either an AZ/EL mount or a polar mount (but not both). You will also need a suitable 3" diameter pole or mount.

Unfortunately, we can no longer obtain the polar mount.

If you have only the 1.2m dish face you will need to order the LNB bracket kit and the kit of 3 "Feed Legs" which support it.

Spare Parts

1.2m dish with AZ/EL bracket screwed to rear and mounted on 3" o/d ground stand.

Send this page address - CLICK HERE - to a friend !