LNB Holders TRX99ZA 40mm LNB bracket with adapter might fit some Sky minidishes |  | This bracket is normally used with a Triax minidish but might fit other Sky minidishes and may give reasonable results, provided that the angle is correct. We recommend that you slide the adapter fully into the dish arm. Then slide the LNB bracket slowly into it and stop when you get maximum signal reading. Adjust the LNB "skew" (rotational position) for maximum signal quality before tightening the small bolt at the top. We can not guarantee good results so please don't ask "will this fit my dish/LNB?" We don't know. Accepts a standard 40mm neck LNB (not a Sky LNB). Dish arm hole dimensions:  | | AP0204806 40mm LNB bracket with adapter might fit some Sky minidishes |  | This bracket is supplied by Fortecstar and may give reasonable results on a Sky minidish, provided that the angle is correct. We recommend that you slide the adapter fully into the dish arm. Then slide the LNB bracket slowly into it and stop when you get maximum signal reading. Adjust the LNB "skew" (rotational position) for maximum signal quality before tightening the small bolt at the top. We can not guarantee good results so please don't ask "will this fit my dish/LNB?" We don't know. Accepts a standard 40mm neck LNB (not a Sky LNB). Dish arm hole dimensions:  | | LNBBRKMK4 Replacement LNB bracket to fit MK4 Sky minidish |  | Fit a MK4 Sky LNB to a MK4 minidish Adjust the LNB "skew" (rotational position) for maximum signal quality before tightening the small bolt at the top. We can not guarantee good results so please don't ask "will this fit my dish/LNB?" We don't know. It's designed to fit a MK4 Sky minidish and matching LNB with 37mm neck. The hole diameter is approximately 37mm and NOT 40mm. | THIS BRACKET IS NO LONGER AVAILABLE SEPARATELY - sorry. | Remove existing MK4 LNB bracket as follows: Use pliers to hold the pin legs together and push it up and out. Use two small flat-blades (screwdrivers or similar), one each side, to push the sides wide and unhook the two tabs. You can then push the LNB bracket up from the back and remove it. Note: the fluorescein dye in the spirit level will fade in sunlight. If you want to keep it bright, cover it with tape, Blu-Tack or something that blocks ultra violet light. LNB30A 28x18mm adapter for MK2/3 Sky minidish |  | Fit a MK4 Sky LNB to a MK2 or 3 minidish Adjust the LNB "skew" (rotational position) for maximum signal quality before tightening the small bolt at the top. We can not guarantee good results so please don't ask "will this fit my dish/LNB?" We don't know. It's designed to fit a MK2 or 3 Sky minidish and a MK4 LNB with 37mm neck. The hole diameter is approximately 37mm and NOT 40mm. | | |