50 cm dish assembly

Please DO inspect the dish assembly on delivery. If there is a problem please REJECT the whole delivery so you don't have to pay for return postage. Cosmetic faults, such as scratched paint, are deemed acceptable because we advise you to paint all parts (except the LNB cap that faces the dish) to protect them from the effects of sun and rain. Matt paint is recommended.

Dents and distortion to the face of the dish (no matter how slight) are not acceptable and you should reject any delivery where there is such damage. Slight rim damage is usually permissible if it does not affect the dish face.

If any parts are missing, please contact our SALES department using the email form and state which parts are missing. Please use the descriptions as shown on the diagram, below, and please enclose this link to THIS page for our Sales girls to click on.

	BEWARE SHARP EDGES! Please check dish face for damage before signing for delivery! The completed assembly Tools required:- 13 mm spanner 10 mm spanner #2 pozidrive screwdriver
	The complete kit. Please count the parts and email us immediately if anything is missing. 1) 1 DISH FACE 2) 1 U TUBE 30 mm dia. 3) 1 20.5x20.5mm LNB ARM 4) 2 LNB CLAMP MOULDINGS 5) 2 BACK PLATE BRACKET SET 6) 1 U BOLT 7) 1 WALL BRACKET 8) 8 PIECES M6 x 12 MM SCREW 9) 2 PIECES M6 X 30 MM HEX SCREW 10) 13 PIECES M6 X 10 MM NUT 11) 4 PIECES M6 WASHER 12) 2 PIECES POZI 20 MM SCREW 13) 1 PIECE M6 X 30 MM HEX BOLT 14) 4 PIECES M8 x 75 mm COACH BOLT 15) 6 PIECES M8 x 13 mm NUT 16) 6 PIECES M8 WASHER 17) 1 PIECE PLASTIC PLUG (ARM) 18) 4 PIECES BRIDGE CLAMP
	Partial assembly (see below)
	Attach LNB holder to arm using one 30 mm long M6 HEX HEAD bolt and one nut. Cover thread copiously with silicone grease.
	Using two long HEX HEAD bolts, washers and nuts, assemble the back plate bracket to the LNB arm. Cover threads copiously with silicone grease. Fit plastic end cap into arm.
	Attach back plate bracket to dish using 4 short square-shoulder bolts and 4 nuts. Cover threads copiously with silicone grease. Note position of arrow shaped hole.
	Fit LNB to plastic clamp using one plastic bridge, two bolts and 2 nuts. Cover threads copiously with silicone grease. Fill 'F' plugs with silicone grease.
	Wall mount dimensions. Place the wall mount plate on a piece of card and mark the hole positions on the card. Use the card as a template to mark the hole positions on the wall. Drill the 10 mm holes in the wall and bolt the mount in position. Coat the bolts with silicone grease before fitting.
The U tube supplied is 30 mm diameter. The back plate bracket can accommodate a tube up to 1.75" (45 mm) in diameter. The instructions supplied on this page are specific to the 50 cm dish. For more details, please refer to our web site technical section and to our eBooks.

©2009-2011 SatCure

 Send this page address - CLICK HERE - to a friend !